February 2016 Commit Log

Number of Commits:
20
Number of Active Developers:
9
jyg 2016-02-28 14:02 Rev.: 2456

Fix to the previous commit

10 lines of code changed in 1 file:

jyg 2016-02-28 13:30 Rev.: 2455

Implementation of a second order distribution on
sub-surfaces of longwave net radiance (Alain
Lahellec).
Introduction of the flag iflag_order2_sollw:
=1 ==> second order distribution.
=0 ==> linear distribution (Default).

81 lines of code changed in 6 files:

musat 2016-02-25 19:39 Rev.: 2454

Supression des moyennes globales du fichier paramLMDZ_phy.nc

5 lines of code changed in 2 files:

fhourdin 2016-02-25 10:52 Rev.: 2453

Filtrage longitudinal du relief dans les hautes latitudes lors de la
creation de l'etat initial. Optionel (filtre_oro=y) et en test.
Optional filtering of the surface orography.

56 lines of code changed in 1 file:

musat 2016-02-24 19:21 Rev.: 2452

Correction bug cas Dice:
- remplace yfluxsens par y_flux_t1 (pbl_surface_mod)
- ajout IF(ok_prescr_ust) pour calcul cdram (screenc)
MPL/JYG/FCheruy

11 lines of code changed in 2 files:

lguez 2016-02-24 16:59 Rev.: 2451

Forgot some accents in previous revision.

3 lines of code changed in 1 file:

lguez 2016-02-24 16:53 Rev.: 2450

Non-ASCII characters in comments are not always rendered properly and they risk being lost. See revision [1740].

15 lines of code changed in 2 files:

emillour 2016-02-23 08:45 Rev.: 2449

Revert to a previous version of the Ada arch file so that people can run "as before", while we investigate if/why/how the change in "mcmodel" and the addition of "openmp-threadprivate=compat" generate issues.
EM

3 lines of code changed in 1 file:

jyg 2016-02-16 19:37 Rev.: 2448

Correction in the computation of qsat in
physiq_mod.F90: the transition of humidity from
saturation over ice to saturation over liquid
water occurs now at rtt (=273.15 K) instead of
t_glace_min or t_coup.

8 lines of code changed in 1 file:

idelkadi 2016-02-16 14:53 Rev.: 2447

Rajout des sorties pour les simulateurs MISR er CLOUDSAT.

296 lines of code changed in 6 files:

fairhead 2016-02-16 14:32 Rev.: 2446

Inclusion des parametres concernant les niveaux verticaux dans un fichier .def separe

-------------
Vertical levels parameters are now defined in a separate .def file

284 lines of code changed in 3 files:

fairhead 2016-02-16 13:46 Rev.: 2445

Latest physiq conf file

0 lines of code changed in 1 file:

emillour 2016-02-16 12:55 Rev.: 2444

Bug fix: Enforcing (in parallel runs) the deactivation of the FFT filter for grids with a zoom in longitude was wrongly implemented.
EM

7 lines of code changed in 1 file:

acozic 2016-02-15 16:31 Rev.: 2443

add some validation tests for aerosols parameters (config_inca, aerosol_couple, flag_aerosol)

20 lines of code changed in 2 files:

fhourdin 2016-02-15 11:10 Rev.: 2442

ngroup passe du statut de paramètre à constante.
Pour pouvoir l'ajuster en fonction de la resolution
ngroup est maintenant lu dans les .def. ngroup=3 par défaut
ngroup changed from parameter to constant

40 lines of code changed in 10 files:

fhourdin 2016-02-12 18:22 Rev.: 2441

Introduction d'une longueur de mélange minimum dans Yamada4 (Cheruy)
Correction du Cd neutre pour chaleur et humidité k^2/ln(z/z0m)/ln(z/z0h)


13 lines of code changed in 2 files:

lguez 2016-02-09 16:45 Rev.: 2440

For read_climoz = 1 or 2, replaced first order conservative regridding
of ozone by second order conservative regridding, with Van Leer
slope-limiting. The replacement is done for both latitude and pressure
regridding. The replacement is beneficial if the resolution of the
input data is coarser than the resolution of LMDZ. If the resolution
of the input data is finer, then the replacement is neutral, it does
not change much.

895 lines of code changed in 9 files:

lguez 2016-02-05 14:32 Rev.: 2439

"-check all" includes "arg_temp_created", which is annoying so we
detail "check bounds", etc.

3 lines of code changed in 3 files:

lguez 2016-02-03 22:45 Rev.: 2438

Bug fix

2 lines of code changed in 1 file:

jghattas 2016-02-03 12:26 Rev.: 2437

Added path to XIOS for ciclad. Change path to INCA as on the other machines.

8 lines of code changed in 2 files:

January 2016 »

Generated by StatSVN 0.7.0