Next: 2 The physical model
Up: 1 Graphical interface
Previous: 1.3 Outputs
Contents
- Launch a first simulation: Click on ''New simulation'', then chose
the input parameters (section 1.2). Launch the simulation
by clicking on the small orange arrow..
- Add another simulation: In the display page, click on the ''+''
icon. Chose the new input parameters.
- Modifiy a simulation name and/or color: In the display page, click
on the ''Curves'' icon. The simulation list appears on the left.
Click on the ''pencil'' icon to edit the name or to select a new
color.
- Show the input parameters for a simulation: In the display page, click
on the ''Curves'' icon.. The simulation list appears on the left.
Click on the ``eye'' to show all parameters.
- Modify the input parameters of an existing simulation: In the display
page, click on the ''Curves'' icon. The simulation list appears
on the left. Click on the ``Key'' icon to come back to the page
where input parameters can be chosen. Once the parameters are modified,
re-launch the simulation by clicking on the small orange arrow.
- Remove a simulation: In the display page, click on the ''Curves''
icon. The simulation list appears on the left. Click on the ``Trash''
icon to remove the simulation.
- Continue the last simulation: In the display page, click on the ''+''
icon. As initial state, chose Final state of the previous
simulation.
- Save simulations, simulation results, or a session:
- Save a simulation to continue it later: In the display page, click
on the ''disk'' icon (figure 6).
- Save the full session: big ``save'' icon (figure 6).
To re-run it later, choose Re-open an old session
in the home page (figure 1).
- Export numerical results from simulations in .csv format: small ``save''
icon (figure 6)
- Export graphical results from simulations in .png format: ``draw''
icon (figure 6)
- Continue a saved simulation: As initial state, chose Fianl
state of a saved simulation.
- Continue a saved simulation: Choose as initial state: ``initial state
of a saved simulation''.
- Show this documentation: click on the home icon near
the top-left corner of all pages.
Next: 2 The physical model
Up: 1 Graphical interface
Previous: 1.3 Outputs
Contents
Camille RISI
2023-07-24